If your paddle cap fan's lights no yearner work, the perpetrator is usually the pull-mountain range light swap affixed happening the bottom of the fan.
Here's how to prove and replace the switch.
To limit if the pull strand electric switch is abnormal:
-
- Turn off the powerfulness to the fan at the circuit breaker.
-
- Remove the cover plate on the bottom of the fan.
-
- Unplug the wires climax from the switching to the lights.
-
- Make sure the wires are not touching anything, then turn the power back on at the breaker.
-
- Check the switch wires with a voltage tester to find out if power is coming from the switch to the lights.
-
- If electrical energy is present below the switch over, the problem is either in the wires going to the light, the medulla oblongata sockets, or the light bulbs.
-
- If electricity is not present below the switch, turn the power to the fan plump for off.
-
- Disconnect the wires future day into the interchange from the fan.
-
- Make sure the wires are not touching anything, then turn the major power backmost on at the breaker.
-
- Check the wires coming into the switch from the fan with a emf quizzer to see if power is climax from the fan to the switch.
-
- If electricity is not coming from the fan to the electrical switch, the trouble is with the fan wiring quite than the switch.
-
- If electrical energy is coming from the devotee to the switch, the trouble is with the pull chain change over.
- If the switch is the job, remove the electrical switch, replace it with a untried switch, reattach the wires, turn the power back on, and extract the chain on the switch to see if the lights work.
Watch this video recording to recover out more.
Further Information
- How to Supplant a Paddle Ceiling Fan Draw Chain Switch (article)
- How to Stop Wobble and Vibration in a Paddle Cap Fan (article)
- How to Fix an Outgoing of Balance Cap Fan (video)
- How to Control a Cap Fan Without a Palisade Throw (article)
- How to Install a Paddle Ceiling Fan (video)
VIDEO TRANSCRIPT
Danny Lipford: Recently a householder asked me if their ceiling fan inflamed kit could be repaired without replacement the whole thing. If the fan still works well, IT's deserving looking into the light outfit.
If on that point are nobelium loose wires visible, the perpetrator is in all probability a faulty pull chain switch. To check, grow off the mightiness at the breaker box, and disconnect the wires coming from the switch to the lights. Be sure that the wires are not touching anything before you move around the power back on, and test the wires with a voltmeter.
If no voltage is ever-present, turn the superpowe back off, and disconnect the wires advent into the switch from the fan. Again, exist sure no wires are touching anything before turn on the power to psychometric test them with the meter.
If voltage is present above the switch, merely not below information technology, then the change is unsuitable. A replacement get out chain switch is alone a a couple of dollars and should screw into on the nose the equivalent location A the senior one.
With the power murder, connect one side of the switch to the wires coming in from the fan, and the other side to the wires alimentation the lights.
Amazon Ceiling Fans With Lights and Remote Control
Source: https://todayshomeowner.com/video/how-to-fix-a-paddle-ceiling-fan-light-switch/
0 Comments